Frequently Asked Question's

 


Getting Started With Advanced Virtual Lab




  • Why would I want to use Advanced Virtual Lab?
  • How do I get started?
  • Can I compare the correctness of experiment?
    • Ans:-Absolutly How to use software simulation?
  • How to Run experiment on real hardware devices?




Drawing/Loading a circuit




  • How do I add a wire on breadboard?
    • Ans:-Move cursour to the starting dot(from where you want to start connection)on virtual breadboard.Then left clickon starting dot.Move cursour(pressing left click on mouse) to the desired dot where you want to end the connection.Then release the left click of mouse.
  • How can I select the Color of Wires?
    • Ans:-To select the colour of wires,go to area above the virtual breadboard.There are four different colours like red,green,blue,black.Click any one for your choice of colour.
  • How to place a device?
    • Ans:-Go to the area above the virtual breadboard.There are different components.Move cursour on any one of the device.Left click on mouse.Keeping press left click of mouse drag/move the desired device to virtual breadboard and then release left click, after putting cursour on any one of the dot at virtual breadboard.




Deleting and Reseting wires/devices




  • How can I delet a wire?
    • Ans:-Click on the wire which you want to delete.It will change the colour of selected wire.Then click on the Delete button which is below the virtual breadboard area.
  • How can I delete a device?
    • Ans:-Click on the device which you want to delete from virtual breadboard area.Then click on Delete button which is below the virtual breadboard area.
  • How can I delete the whole circuit in one go?
    • Ans:-Click on the Reset button which is below the breadboard area.




Input and Output Devices




  • How to set input signal for experiment?
    • Ans:-Click on the FUNCTION GEN button.It will open function genearator in a new window/tab.From here you can change Frequencey/Amplitude of applied signal.
  • Where to observe output of experiment?
    • Ans:-On oscilloscope.




Running and Saving the Drawn circuit




  • How to run the experiment?
  • How to save the Schematic information?